The content you were about to view is not suitable for minors.
The page that you are trying to access contains adult content, which may not be suited for minors. Please verify that you are aware of this, and are within legal age limit to access this content. Note that we take no responsibility for any content if you decide to proceed to this page as a minor.
Images posted in this section must comply with the Mecabricks rules. Please read carefully the rules before publishing.
by
No renderings uploaded yet
398
24
About
Inventory
Share
From Wookieepedia: Heavily armored and jet-propelled, the blaze troopers were hulking figures in their heavy combat armor, which appeared similar to that later worn by the Imperial Zero-G assault stormtroopers.
They were tasked with "blazing" through enemy lines and clearing accumulated battlefield debris out of the way of advancing infantry, using their wrist-embedded flamethrowers.
Their preferred method of attacking Jedi and most ground enemies was to rush them using their backpacks to increase their speed, and either backhanding the target while flying past or putting a target in a bear hug before slamming them into the ground where upon they would use their flamethrowers on their opponent.
Just found out about these brutes recently, and had to make one.
Partially inspired by NGCHunter2's Master Chief model, and built as illegal as a monkey owning intellectual property. That could also be advertised as: *Digitally Exclusive Model!*
@ApocalypticBrick Thanks! It took time, strategic lighting placement, and work. Snow was composited in post, and colour has been played with as well.
Take time to learn Blender and work with methods that you haven't used before. Watch lots of tutorials and just tinker and tinker with things. Eventually, with time and patience, you'll get really good.